Payment & Shipping Terms:
fly ash brick making plant,
AAC brick Plant
New Style Autoclaved Aerated Concrete Plant Sand Lime Brick Manufacturing Machine
1.AAC block plant preparation work
1. Land of 4 Acres is Required
2. Workshop area –approximately 6000 Sq Mt
3. Total Plant area( construction area ) = 15000 Sq Mt
4. Power connection needed – 500 KVA
5. Ideal manpower requirement is 40 nos. (Skilled – 10, semi skilled-10 and unskilled 20)
6. Skill division 40 workers = Main plant 2 nos of 10 hour shifts 15 people each + Boiler & Autoclave section 3 people in 3 shifts of 8 hours
7. Water requirement approximately 225 Tons per Day.
8. Fly Ash requirement approximately 225 Tons per day
9. The above power and plant calculations are based on Fly ash based AAC without Lime Crushing Unit and Ball mill for sand. If the process so require, we may add them at a later stage. But surely we give provisions for them at site right from installation stage
10. 300 working days is considered in a year through 333 days a year is possible.
11 Fly to be provided free of cost by power plants. Only transportation to be arraigned by Project. Average distance of 250 KM
12. Carbon Credit is estimates are for reference purpose. The Project owner must handle his part of CDM project to get Carbon credits, through independent consultants. Please check the form of CDM after 2012
13. AAC Blocks of all sizes will be manufactured according to the market requirement, though mainly stipulated sizes as per the BIS standards.
2.AAC BLOCK PLANT WORKING PROCESS
The Process of manufacture is simple t follow, and complex to implement.
First, the Fly Ash or sand is mixed with water, and made Slurry in a slurry mixture. If Sand is used as a base material, we need a ball mill to grind the sand to fine power. The slurry making process is same sand.
After Slurry is made, the slurry is stored in slurry storage tank, where the slurry is constantly agitated. Care is taken to run the slurry storage tank all the time, so that is never settles down the particles.
Then a weigh batcher weighs the Slurry, lime, OPC, Gypsum and aluminum power in preset quantities, and mixes thoroughly. The mixture also pours the mix into the Mould carried n the mould cart. The full pouring of the mixture is just enough to fill around 50% of the mould.
Then the mould is kept in a warm chamber for 2 hours, so that the aeration and the light initial setting takes place. Next process is de-molding process of the big block, in which a sophisticated overhead hoist takes the mould, demoulds the block.
Next process is the level wire cutting of the Block, while the block passes on the cutting trolley through the series of wires. This process follows a vertical wire cutting where as the block remains stationary, and the cutter cuts the block vertically.
3.AAC block advantages
1. Environmental friendly: needs no burning/backing
2. Strength: Higher Strength Bricks.
3. Uniform Shape: Easier and faster Brick working.
4. Uniform Shape: Less Mortar in Brick work.
5. Uniform Shape: Less Mortar in Plaster.
6. Natural Concrete: Gains strength over time.
7. Natural Concrete: Walls can be left exposed/un pl
8. Better heat & sound insulation compared to red B
9. Far Lesser brakeage during handling & transporta
10. Better Vibration resistance compared to red Brick
11. Light weight : Faster and easier transportation
12. Light weight : Faster and easier brickwork
13. Light weight : saves structural concrete by 35%
Contact Person: tt